JOI 2025

The variably adjustable tilt angle and the horizontal direction of rotation (360°, 12 positions) can be set quickly and easily with just one wing nut. The design allows the rod to be quickly removed from the fork. Both the support fork and the locking ring with a diameter of approx. 50 mm are coated with black plastic to protect the rod. These rod holders are very popular for down riggers or planer boards (seal). The tube has a length of 26.5 cm and fits all standard rod handles. The contact edge to the rod is fitted with a black plastic cap. The angle of inclination of the tube can be adjusted in 6 positions using an adjusting screw. The horizontal direction of rotation (360° 12 positions) is set using an Allen screw. RH-5612 Complete set with square (57.2x 57.2 mm) standard mounting plate made of aluminum including rubber seal. Suitable for mounting on flat surfaces. 59 7088 RH-5715 Complete set with clamping bracket for wall thicknesses up to 57mm. 59 7081 RH-5716 Complete set with railing bracket, sui- table for round and square railing tubes up to approx. 30 mm diameter. 59 7082 RH-5712 Complete set with standard square mounting plate made of aluminum including rub- ber seal. Suitable for mounting on flat surfaces. 59 7083 RH-5620 Tubular rod holder without moun- ting unit. This model has a fixed tilt angle of approx. 30 degrees, but this rod holder can be tilted into the boat without using an adjusting screw to set the hook and rod. 59 7073 RH-5750 Tube rod holder without mounting unit. This model is specially designed for rods with multi-reels so that they can be stored in the holder without twisting. Tube length approx. 25cm, angle of inclination either 30° or 45°. 59 7075 NG-5742 Short tube holder, especially for net or gaff with standard aluminum mounting plate inclu- ding rubber seal. Suitable for mounting on flat sur- faces. However, the tube can also be attached to alternative mounting units and can be rotated 360°. 59 7093 Pedestal for up to 3 rod holders from Tite Lok. The rod holders are easy to mount and remove and allow 360 degree rotation of each rod holder. inclu- ding mounting kit Size of the upper base: 40.6 cm (16") Size of the lower base: 10.2 x 7.6 cm Height: 7.6 cm 59 7053 RH-5618 Complete set with large clamping bracket. Thanks to the recess in the bracket, this mo- del not only fits on the transom, but also on almost all hulls, including those with a coaming. As the fork rod holder can be attached not only to the top of the clamp, but also to the end of the clamp, there are additional mounting options. This screw clamp is suitable for wall thicknesses up to 50 mm. 59 7086 RH-5610 Fork rod holder without mounting unit. 59 7077 other pipe holders P edestal for rod holder P ipe rod holder F ork rod holder 597081 597082 597083 597074 597077 597088 597086 RH-5710 Pipe rod holder without Mounting unit. 59 7074 597093 597075 597073 73 TITELOK ROD HOLDER