JOI 2026 EN

With just one wing nut, the variable tilt angle and horizontal rotation (360°, 12 positions) can be adjusted quickly and easily. The design allows the rod to be removed from the fork quickly. Both the support fork and the retaining ring, which has a diameter of approx. 50 mm, are coated with black plastic to protect the rod. These rod holders are very popular for downriggers or planer boards (Seehund). The tube is 26.5 cm long and fits all standard rod handles. The contact edge to the rod is fitted with a black plastic cap. The angle of inclination of the tube can be adjusted to 6 positions using an adjusting screw. The horizontal direction of rotation (360°, 12 positions) is adjusted using an Allen screw. RH-5612 Complete set with square (57.2 x 57.2 mm) standard mounting plate made of aluminum with rubber seal. Suitable for mounting on flat sur- faces. 59 7088 RH-5715 Complete set with clamp bracket For wall thicknesses up to 57 mm. 59 7081 RH-5716 Complete set with railing mount, sui- table for round and square railing tubes up to approx. 30 mm in diameter. 59 7082 RH-5712 Complete set with square standard mounting plate made of aluminum including rub- ber seal. Suitable for mounting on flat surfaces. 59 7083 RH-5620 Tube rod holder without mounting unit. This model has a fixed angle of inclination of approx. 30 degrees, but the rod holder can be tilted into the boat without using an adjustment screw to set the hook and rod. 59 7073 RH-5750 Tube rod holder without mounting unit. This model is specially designed for rods with multi-reels so that they can be stored in the holder without twisting. Tube length approx. 25 cm, angle of inclination either 30° or 45°. 59 7075 NG-5742 Short tube holder, specially designed for nets or gaffs with standard aluminum mounting plate and rubber seal. Suitable for mounting on flat surfaces. However, the tube can also be attached to alternative mounting units and can be rotated 360°. 59 7093 Platform for up to 3 rod holders from Tite Lok. The rod holders are easy to install and remove and allow each rod holder to rotate 360 degrees. Includes mounting kit. Size of upper base: 40.6 cm (16") Size of lower base: 10.2 x 7.6 cm Height: 7.6 cm 59 7053 RH-5618 Complete set with large clamp bra- cket. Thanks to the recess in the bracket, this model not only fits on the transom, but also on almost all side walls, even those with a coaming. As the fork rod holder can be attached not only to the top of the clamp, but also to the end of the clamp, there are further mounting options. This screw clamp is suitable for wall thicknesses up to 50 mm. 59 7086 RH-5610 Fork rod holder without mounting unit. 59 7077 other pipe brackets P latform for rod holders T ube rod holder F ork rod holder 597081 597082 597083 597074 597077 597088 597086 RH-5710 Tube Rod Holder without 59 7074 597093 597075 597073 73 TITELOK ROD HOLDER